Article ID : S500008676 / Last Modified : 11/04/2018

What to do if there is no sound input from the audio device that is connected to Roland's EDIROL UA-5 even after setting the system in recording standby state?

Applicable Products and Categories of This Article

There is no sound input from the audio device that is connected to Roland's EDIROL UA-5 even after setting the system in recording standby state.

To resolve this symptom, please perform the following adjustment on EDIROL UA-5:

A. When the audio device is connected to the Input 1/L Input jack 1 or the Input 2/R input jack 2 located on the front panel of EDIROL UA-5:
Turn SENS (input sensitivity knob) clockwise to increase the input level.
Use respective SENS (input sensitivity knobs) to adjust Input 1/L and Input 2/R.

B. When the audio device is connected to the Input L/R input jack 3/4 located on the EDIROL UA-5 rear panel, turn INPUT VOLUME (input jack 3/4 adjustment volume) clockwise to increase the input level.

If the problem persists, please refer to the Startup Manual supplied with EDIROL UA-5 or visit Roland's website for more information.